Blending Board Cloth CUSTOM ORDER overrun - in continuous foot lengths (12" wide) A purchase of “1” gets you a 12" wide by 12" long piece of cloth We do not advertise the TPI as, unlike carding cloth, it isn’t the most important variable in what makes BLENDING cloth function as it should. Please read more of what makes it special in the full description below: (That being said, the tooth setting makes it comparable to a 72 TPI) All sales final For a purchase of “1,” we remove the teeth on the side & the top & bottom of the 12 x 12" square so that you can easily & immediately install the clothing to your board without extra work! ABOUT BLENDING CLOTH After extensive research & development, Howard Brush came up with a combination of variables that were the ideal makeup for a cloth used specifically on a blending board. Blending cloth has longer teeth, a different, more open tooth pattern, & the finish on the tip of the wire is such that it is less likely to hurt your hand since there is so much more contact using a blending board than with hand or drum carders. Regular carding cloth has a shorter tooth in comparison to blending cloth, a more closed tooth pattern, & the finish on the tip is a bit more aggressive. The special fabrication & design of blending cloth makes it ideal for handling a spectrum of materials; normal fleeces, & not so normal fun additives; feathers, bits of cloth, etc. On top of that, the makeup of the tooth itself is best suited for the process of evenly blending, & uniformly removing. Blending Board Cloth Overrun - in Continuous Foot Lengths